HRT Can-Am X3 Billet Radius Rod Plate 2022-2023

In stock!

The STRONGEST radius rod plate on the market!! Don't get fooled into buying other brand thin sheetmetal upper and lower attachments!

We offer the first ever 2022 billet X3 radius rod plate.   This is just like our 2017-2021 model plates but comes with the new upper and lower billet aluminum bolt on mounting hole attachments.  In 2022 Can-Am redesigned the rear bulkhead on the chassis adding four extra holes two above the upper radius rods and two below the lower radius rods. 

Our plate and attachments are machined in house from 6061 aluminum 1.250" thick x 8" wide for the main plate, the 2022 upper attachment is 2.50" x 2.750" thick 6061 billet aluminum and the 2022 lower attachment is machined from 2" x 2.50" thick 6061 billet aluminum.  The Main plate is drilled and tapped on the top and bottom to allow the upper and lower plates to be bolted on with counter sunk 3/8" stainless allen cap bolts.  All anodized plates are contrast cut after anodizing to make them pop and look like jewelry.  All Plates come pre-assembled ready to bolt on!

The best part of this design is you can use this plate on 2017-2021 X3 chassis you just have to drill 4 holes for ultimate rear bulkhead support!

• HRT Face plate option allows you to remove the faceplate, this allowed us to give you the option to make a faceplate that you can tie the rear bumper into the radius rod plate.  Our mount plate is machined from billet 3/8" 6061 aluminum with counter sunk 1/4" stainless allen cap bolts.  The bumper mount plate is the same but with two 1.5" receiver grooves machined in the face and comes with 1.5" 1018 CRS round steel billet weld fittings that are machined for .120 wall tubing, tapped enabling them to bolt to the face plate and lightend in the inside for weight reduction.  This allows you to easily remove your rear bumper by unbolting the face plate screws or the 2 weld fitting bolts!

• HRT Billet D-Rings that can be mounted vertically or horizontally and are recessed into the plate face itself for maximum rigidity and strength with an ever so slight contour machined in the side to jazz up the plain look.

• HRT Mud Plugs are machined billet aluminum finishing caps that go in the D-ring holes you don't use to keep the mud out and give it a great look! Caps are also contrast cut after anodizing.

• HRT 2" Receiver Hitch attachment is machined from 6061 billet aluminum and utilizes all 4 mounting holes. (There is a 3 week lead time)

We offer each part in raw aluminum and anodized black, more anodizing colors and chassis powdercoat colors coming soon! (please reach out for custom colors)

Make sure to check out our Billet stainless Radius rod gussets for strength and individual Radius rod bolt removal!

Made in USA!

Designed and machined in house!

Full lifetime warranty against any workmanship and defects!